Re-Hitch Level

[TravelinAnderson]

As you know the memory function of the Level-Up system doesn't always work the way we want it to so we have to manually set the pin height when we hitch up the trailer. I figured there had to be a way to set the height without asking my wife for help or backing up, getting out to set the height then get back it the truck to back it in. This is what I came up with.


After you drop the landing gear and are ready to unhook your truck simply adjust the level so the bubble is centered then unhook. When it's time to re-hitch just raise or lower the pin height to get the bubble back to center and you're ready to hook up.
On the door to the Level-Up control panel there's a peg with a hole in it so attaching the level was easy. Just tighten the screw enough to hold the level in place but still allow you to move it for adjustments.
Edited by: TravelinAnderson

[mhs4771]

Neat idea Steve, there is also a little level with a slideing section you can set as you disconnect and bring the unit back to that same spot when ready to hook-up.

[COLJDM]

Steve, damn fine idea. I will go out tomorrow and buy a small level. Thanks
John