Auto level not level

[brenkco]

I have only used the level up system a few times but it always leaves me low in the front. It is significant enough for cabinet doors, doors etc to not stay open. I have been able to easily raise the front using my torpedo level for reference.

Should I expect this or are their adjustments that can be made?

Thanks,

Ken

[Oriana]

Ken,

You can manually level the coach and then using a series of button presses you can enter the new level position into the system. The process is available in the Lippert manual.

[Adamsvr]

As Oriana said, level your coach manually on the LCI keypad, you'll see front to back, and side to side leveling. Once these are set, turn the LCI keypad off and push the up arrow off ten times and then the down arrow tens times. This will reset the zero point calibration. Next time you hit Auto Level, it will return to that setting.

[brenkco]

Thank you, that was easy! I appreciate the help!!!

Ken

[Adamsvr]

You are welcome. Anytime you have a problem with your Redwood, don't hesitate to reach out to this forum. Vic