auto level

[pipeliner798]

Made the maiden voyage with no problem. My question is when I hit auto level one of the legs in the middle is barely touching and on the other side is about 2 inches from touching but says success on the display . Is this normal and if not what do you do?

[UNDRPSI]

I pretty sure that is not normal. I would cycle the jacks a few times or at least manually level it and reset level.

[Dave&Ginny]

Mark,

Chuck is right, I'd run the jacks up and down a few times and make sure they're extending all the way. Also try checking your fluid level and make sure you have enough. Next, there are 2 boxes with wires going to them in your basement( on my RL they're on the port side up right behind the leveling pad area). There are directions on them printed on how to reset the system. One of those boxes is for the leveling system and the other is for the slides (I believe). This is going to take a flash light, reading glasses and about 4 fingers of Jack.

Good luck

Edited by: Dave&Ginny

[atom ant]

I may have had too much Jack myself, but if I remember, if you overextend a jack the system will alarm and says overextended, but if you acknowledge it the message rolls to succesful.

[sinder]

<div ="page" title="Page 3">
<div ="layoutArea">
<div ="column">


Manually level your coach and follow the steps below.</span>

ZERO SETTING THE CONTROL
</span>


1. Turn “ON/OFF” button “OFF”

2. Push “FRONT” button 10 times,

3. Push “REAR” button 10 times

4. Control will flash and beep, LCD says “ZERO POINT CALIBRATE”
5. To memorize this level condition , press “ENTER”

6. LCDsays“ZEROPOINTSTABILITYSUCCESSFULLYSET”

7. The control will then turn off.

8. Turn “ON/OFF” on to commence operation.</span>

[johnboytoo]

FYI - 3 suspicious post from this new user - I would suggest you not follow the links in his signature