Forum: Redwood Care and Feeding
01-03-2017, 02:03 PM
|
Replies: 49
Views: 7,174
I tried to remove the outside trim to change...
I tried to remove the outside trim to change mine, way, way, way too much work. There are about 10 screws and caulk on the trim panel, then once you pull the seal back, there are 6 pop-rivets to...
|
Forum: Redwood Care and Feeding
12-15-2016, 01:53 AM
|
Replies: 49
Views: 7,174
|
Forum: Redwood Care and Feeding
12-14-2016, 02:24 PM
|
Replies: 49
Views: 7,174
Shane, I removed the screws on the outside and...
Shane, I removed the screws on the outside and used a pick to push the motors out of the slot, then tried to move the slide and didn't work, made sure the slide was still on track. Wouldn't budge. ...
|
Forum: Redwood Care and Feeding
12-14-2016, 01:53 AM
|
Replies: 49
Views: 7,174
I tried with a couple friends to push it in,...
I tried with a couple friends to push it in, tried tilting the whole rig down on the right side and pushing, tried the unplugging, tried the 7 button sequence, even tried a tow strap and pulling it...
|
Forum: Redwood Care and Feeding
12-13-2016, 11:47 PM
|
Replies: 49
Views: 7,174
bedroom slide
Slide is finally in. Bad control board and motor. Although I couldn't find any leaks, motor was rusted. There was no way in the world to get that slide in without the motors working. No errors on...
|
Forum: Redwood Care and Feeding
11-15-2016, 01:13 AM
|
Replies: 49
Views: 7,174
Dave that gives me a better idea of what I'm...
Dave that gives me a better idea of what I'm looking at. I'm going to try and get it in a little bit so I can reach it. Is there a screw on the outside on Redwoods? My plan is to remove power,...
|
Forum: Redwood Care and Feeding
11-14-2016, 02:03 PM
|
Replies: 49
Views: 7,174
|
Forum: Redwood Care and Feeding
11-14-2016, 01:01 AM
|
Replies: 49
Views: 7,174
Bedroom slide
Knew it was going to happen, just hoped it would be later in life. Winterized today, went to pull in bedroom slide and only one side pulls in. I can hear both motors working, no error codes on the...
|