Reply
 
Thread Tools Display Modes
 
Old 11-23-2014, 11:43 PM   #21
Senior Member
 
travelin' texans's Avatar
 
Join Date: Sep 2012
Posts: 2,828
Forgot to answer all your question, I only use those straps if the wind is fairly strong, as those screens do a good job of holding the awning in mild/moderate winds.
__________________
Danny & Linda
Former '13 FB owner
Currently rvless!
travelin' texans is online now   Reply With Quote
Old 11-24-2014, 01:39 AM   #22
Senior Member
 
atom ant's Avatar
 
Join Date: Feb 2013
Posts: 7,094
Thanks Danny!
__________________
Brad & Dory - Lone Tree, CO
CURRENT - 2013 Itasca Meridian 42E/2013 Wrangler 4dr Sahara
SOLD - 2014 Redwood 36RL/2014 F350 DRW
atom ant is offline   Reply With Quote
Old 11-24-2014, 01:48 AM   #23
Senior Member
 
johnboytoo's Avatar
 
Join Date: Jul 2013
Posts: 2,054
I got my bro-in-law to bend me four 'hooks' to slip over the roller tubes so I don't have to get the ladder out.

Works like a champ !!! with carabiners and a bungee cord on the ends, gives just enough GIVE to allow some bouncing without breaking...
Attached Images
File Type: jpg Arlington-20140526-00321.jpg (269.2 KB, 3 views)
__________________
Ours: '11 Monaco Diplomat 43DFT followed closely by '14 Jeep 4 dr Wrangler.
Hers: '13 Explorer Sport - AWD 365hp twin turbo scooter!
Previous: '13 Ford F350 CC Platinum and '13 38GK
johnboytoo is offline   Reply With Quote
Old 11-24-2014, 02:14 AM   #24
Site Team
 
Dave&Ginny's Avatar
 
Join Date: Jan 2012
Posts: 5,379
Quote:
Originally Posted by johnboytoo View Post
I got my bro-in-law to bend me four 'hooks' to slip over the roller tubes so I don't have to get the ladder out.

Works like a champ !!! with carabiners and a bungee cord on the ends, gives just enough GIVE to allow some bouncing without breaking...


That's a great idea!
__________________
SOB "The RV Wiseguy"
Dave&Ginny is offline   Reply With Quote
Old 11-24-2014, 03:50 AM   #25
lwg
Senior Member
 
lwg's Avatar
 
Join Date: Jun 2013
Posts: 918
I have the shades that are made by the same manufacturer as our awning and they retract up with the awning. To tie them down I just use 3 bungee cords to hold them in place. It allows the awning to bounce a little and I can remove the cords and retract the awning in seconds in the case of sudden gusty winds.
__________________
2014 Redwood 38BR, Fulltiming
2013 Ford F-350 CCSB 6.7L 4x4 SRW, B&W Companion Hitch, Air Bags
lwg is offline   Reply With Quote
Old 11-24-2014, 02:08 PM   #26
Senior Member
 
Join Date: Dec 2013
Posts: 139
[QUOTE=NW Snowbirds;40476]The pins were put in to anchor the awning during installation and were supposed to be removed. If they are not removed they can cause problems with the mechanism. Our awning is presently being replaced under warranty because the combination of the cotter pins and improper alignment of the struts has resulted in fabric stretch/failure and the idler roller has extreme wobble. Get rid of the pins ASAP.

Hi NW Snowbirds....Can you further explain failure? We had a wobble, fabric stretch, ( our dealer had tightened the fabric) and our first rain, ended up with a huge belly of water that broke our front arm.
Thanks
Don
Don and Judith is offline   Reply With Quote
Old 11-24-2014, 09:05 PM   #27
Senior Member
 
NW Snowbirds's Avatar
 
Join Date: May 2013
Posts: 296
Send a message via AIM to NW Snowbirds
After a year and a half of use I opened the awning at home this summer and saw holes thru the fabric. There were many pinholes allowing the sun to shine thru and there were rips about one to two inches long that all aligned parallel to the roller. The side tape also was ripped in two places. All of the damage was in the area about 6 ft by 6 ft at the idler roller end and up toward the top of the awning. On investigation I discovered the installation alignment cotter pins were still in place on the top side of the idler roller and were rusted. I searched for a Carefree installation manual on line (none was supplied with the delivery of the RW) and there were clear instructions to remove the cotter pins after installation. When I removed the cotter pins the idler started wobbling and lurching when the awning was extended or retracted.

I called Carefree and they directed me to take the unit to an authorized Carefree warranty dealer for inspection. The dealer tech found that the awning strut assembly on the idler end was out of plumb by about 1+" from bottom to top and advised me to stop using the awning. Since the cotter pins were not removed and the strut was misaligned he determined it was not a Carefree warranty problem. I spoke to a Carefree tech again and they told me that the problems were most likely caused by the misalignment and cotter pins, and to take the problem up with Redwood. I sent photos and a video to RW and they had me take the unit to a local RV dealer where they awaiting parts to replace the hardware and fabric as well as correcting the strut alignment.
Attached Images
File Type: jpg Awning deterioration.jpg (64.1 KB, 1 views)
File Type: jpg Side tear (2).jpg (104.6 KB, 1 views)
File Type: jpg Awning Pins - Copy.jpg (203.8 KB, 3 views)
__________________
2012 Redwood 31SL chasing 2013 GMC 2500HD Duramax SRW
NW Snowbirds is offline   Reply With Quote
Old 11-24-2014, 09:07 PM   #28
Senior Member
 
johnboytoo's Avatar
 
Join Date: Jul 2013
Posts: 2,054
fyi, no pics attached NWS....
__________________
Ours: '11 Monaco Diplomat 43DFT followed closely by '14 Jeep 4 dr Wrangler.
Hers: '13 Explorer Sport - AWD 365hp twin turbo scooter!
Previous: '13 Ford F350 CC Platinum and '13 38GK
johnboytoo is offline   Reply With Quote
Old 11-24-2014, 09:10 PM   #29
Senior Member
 
NW Snowbirds's Avatar
 
Join Date: May 2013
Posts: 296
Send a message via AIM to NW Snowbirds
Quote:
Originally Posted by johnboytoo View Post
fyi, no pics attached NWS....
Got it
__________________
2012 Redwood 31SL chasing 2013 GMC 2500HD Duramax SRW
NW Snowbirds is offline   Reply With Quote
Old 11-25-2014, 12:10 AM   #30
Senior Member
 
atom ant's Avatar
 
Join Date: Feb 2013
Posts: 7,094
what causes the wobble? Mine was bobbling and noticed the screws had stripped out of the awning tube where the idler attaches. I fixed that but it still wobbles. Guess I better check It out more.
__________________
Brad & Dory - Lone Tree, CO
CURRENT - 2013 Itasca Meridian 42E/2013 Wrangler 4dr Sahara
SOLD - 2014 Redwood 36RL/2014 F350 DRW
atom ant is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Redwood RV or any of its affiliates. This is an independent, unofficial site.


All times are GMT +1. The time now is 01:09 AM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2019, vBulletin Solutions, Inc.